beautypg.com

INFICON Explorer Portable Gas Chromatograph User Manual

Page 35

background image

Introduction

To remove the battery pack:

1. If the instrument has been turned on, turn it off by pressing the On/Off key and

pressing YES.

2. Use the hex key from the Tool Kit (MX380334) to loosen the four captive

screws in the bottom of the battery pack.

3. Disconnect the battery pack from the instrument.

4. Replace the battery pack with a charged battery pack.

5. Clean the seal on

Explorer and the rim of the battery pack of all dirt.

6. Align the connectors on the charged battery pack to the connectors at the rear

of

Explorer.

7. Secure the battery pack by tightening the 4 captive screws.

Do not over-tighten the screws.

Captive Screws

Battery Pack

Connectors

Explorer

Battery Pack

Seal

Figure 2 Removing Battery Pack

33