ETC Echo Inspire Station - Manual (Page 7)

E T C I n s t a l l a t i o n G u i d e
Station Installation
Page 7 of 8 Inspire Station Installation Guide
Install the Station into the Back Box
Spacers are provided to help align the station and cover flush against the wall
in flush mount application. The spacers are not required when installing the
station into a surface mount back box.
Step 1: Insert the station electronics and wiring into the back box. To install
multiple stations (multi-gang), insert the station electronics into the
back box from the right to the left side for the best alignment and fit.
The alignment bracket will slightly overlap the station to the right when
properly installed.
Step 2: Use receptacle spacers as needed to provide a flush mounted station.
a: Fold the spacer in a zig-zag fashion and press the stack together to
achieve the thickness needed to fill the gap between the station, wall
surface, and the back box.
b: Cut off and discard the excess.
c: Place the stack between the station electronics and the flush mounted
back box.
Step 3: Secure each station electronics in place using the two screws
provided. If using spacers, insert the screws through the spacers as
well.
CAUTION: To improve successful station and wall plate installation, do not
over tighten the screws. If screws are over tightened, button
activation can be negatively impacted.