beautypg.com

Record / program mode (button/led), Station installation, N o t e – ETC Echo Inspire Station User Manual

Page 4

background image

E T C I n s t a l l a t i o n G u i d e

Station Installation

Inspire Station Installation Guide

Page 4 of 8

Record / Program Mode (button/LED)

The Record / Program Mode button sets the station into either “Record” or
Program” mode.

Record Mode (snapshot)

Step 1: Press the [RECORD/PROGRAM MODE] button, an amber LED will

blink during a 10 second record period.

Step 2: Press the Preset button of the preset you would like to record

(snapshot). This stores current levels to the designated preset. If no
presets are designated or if you press the [RECORD] button again, the
record action is canceled.

Program Mode

Press and hold the [Record/Program Mode] button for 3 seconds to enter
Program Mode”, the Mode LED lights (steady amber). Program Mode allows
adjustment of the consecutive range of Presets or Zones depending on the

Function Selector Switch

position.

When the “Preset” function selector switch is set, the first preset
button on the station blinks its LED indicating the number of the
current (first) preset controlled.

Step 1: Press and release the preset button the number of times to set the new

preset start number. (For example: press and release ten times to set

the first control to be Preset 10.) Remaining buttons will be

consecutively numbered.

Step 2: Press and release the [Record/Program Mode] to exit Program Mode

and save the current setting.

When the “Zone” function selector switch is set, the first zone
raise or toggle button LED flashes the number of the current
(first) zone controlled.

When the “Custom” function selector switch is set, the station
mimics the default preset behaviors. Program mode has no affect
on functions stored in association with custom configurations.

Program Mode - E1004 Button Station Set to Space Combine Mode

Program Mode functions in a different manner when dip switch 3 on the rear of
the 4 button station is set to space combine mode.

When dip switch number 3 is set to On, and the

Function Selector Switch

is set

to Preset, the 4 button station changes to support space combine actions. The
first button LED flashes, indicating the current first space combined. Any
subsequent button presses allows you to change the specification of the first
consecutive space combined.

N o t e :

The first zone raise or toggle button may not be the same control

as the first preset button on a station.