ETC Unison Paradigm 18-inch Touchscreen Setup and Connect Guide - Manual (Page 4)

E T C S e t u p a n d C o n n e c t G u i d e
Paradigm
®
18 inch Touchscreen
Paradigm 18 inch Touchscreen Setup and Connect Guide Page 4 of 12 Electronic Theatre Controls, Inc.
Notice the lower right hand corner of the shell displays software versions of both the “Shell Version” and
the “App Version”. The “App Version” represented is the version of Paradigm Virtual Touchscreen
software that is currently installed.
Three tabs are located on the Application Shell including “General”, “Device Setup” and “Advanced”.
General Tab
The “General” tab is provided as the interface to launch and manage the Paradigm Virtual Touchscreen
(P-VTS) software.
[Launch Virtual Touchscreen]
To launch the Paradigm Virtual Touchscreen “P-VTS” software, touch the [Launch Virtual
Touchscreen] button located on the “General” tab.
The P-VTS application launches to the “Discovered Servers” list. Select the Central Control Server to
continue with Virtual Touchscreen configuration selection.
The Paradigm Virtual Touchscreen Setup Guide is available for download on the ETC website at http:/
/www.etcconnect.com/downloads.aspx.
P-VTS Install Management
This section of the “General” tab provides the ability to [Uninstall] the Paradigm Virtual Touchscreen
(P-VTS) software, or install a newer version from either removable media or the connected Paradigm
Central Control Server (P-CCS).
N o t e : The Application Shell software is included with each installation of the P-TS18.
Updates to the shell are combined with Paradigm Virtual Touchscreen application
when necessary.
N o t e : Touchscreen configurations are created in ControlDesigner and associated to a
Virtual Touchscreen (VTS) instance in LightDesigner. Reference the online help
systems for LightDesigner and ControlDesigner for details to create and associate
Touchscreen configurations.
N o t e : If a current version of the P-VTS software is installed, the [Install from Removable
Media] and [Install from Online P-CCS] buttons are disabled. You must first
[Uninstall] the software before installing a new version.