ETC Unison Paradigm 18-inch Touchscreen Setup and Connect Guide - Manual (Page 3)

E T C S e t u p a n d C o n n e c t G u i d e
Paradigm
®
18 inch Touchscreen
Paradigm 18 inch Touchscreen Setup and Connect Guide Page 3 of 12 Electronic Theatre Controls, Inc.
P-TS18 Initial Power-up
To power-up the Paradigm ® 18 inch Touchscreen, press the power button on the front panel.
Because ETC has prepared the P-TS18 at the factory prior to shipment, on initial power-up, the
Paradigm Virtual Touchscreen application loads.
Application Shell
The Application Shell includes the interface to launch the Paradigm Virtual Touchscreen (P-VTS)
software, which was has been previously installed at the factory before shipment. In addition, the
Application Shell provides access to the P-TS18 IP and network settings, as well as more advanced
features which are password protected.
To continue with selecting a Virtual Touchscreen configuration,
touch to select the “Central Control Server” from the
“Discovered Servers” list. Reference the Paradigm Virtual
Touchscreen Setup Guide for instructions to use the P-VTS
software.
To update the Virtual Touchscreen application, to change IP or
network settings, or for additional advanced features and
troubleshooting, touch the [Quit] button on the bottom right
corner of the P-VTS application. The P-VTS software
application closes and the Application Shell displays.