Despatch Protocol 3 Controller - Manual (Page 32)

W ORKING WITH O PERATING M ODES Protocol 3 Controller Owner’s Manual
32 Version 1.2
Copyright © 2013 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
Table 12. Profile Setup Steps, Options and Descriptions.
Step # Protocol 3 Descriptor
Option Description
General Configuration
1. Remote Profile Control
Disabled Disallow a remote source to run a profile
Enabled Allow a remote source to run a profile
2.
Automatic Start
Disabled Disallow use of delayed start time
Enabled
Allow controller to start at a later time with
programmed delay
Create a Profile
3. Enter a Profile Name
Unique name for each profile using up to 8
characters
4. Profile Start Trigger
None Profile start not delayed
After Delay
Set hours and minutes to delay before
starting the profile
Day and Time
Set time of day (hour and minutes) and day
of week to start profile. Options include
each day of the week and combinations of
days.
5.
Profile Recovery
Method
If power-down occurs while this profile is
running, specify the action for the controller
to take during power-up:
Control Off Controller goes to OFF
Restart Profile Controller restarts current profile
Maintain Last
Profile SP Controller maintains previous profile
setpoint
Continue
Profile Controller continues (for specified time) the
profile from where it was when power
failed.
Profile Abort Action
If program aborts, profile should:
Control Off Controller goes off
6. Maintain Last
Profile SP Choose the number of times to cycle the
program, up to an infinite number of times.
Edit a Profile Segment
7.
Edit Segment Number
Ramp Time 
Set target setpoint (degrees centigrade)

Set the segment ramp time (hh:mm:ss)

Set the Auto-Hold Type: None, Above
Setpoint, Below Setpoint, Band.

Set Events 1-5: Press or to
toggle between Active and Inactive.
8. Ramp Rate 
Set the target setpoint (degrees
centigrade)

Set the segment ramp rate in units per
hour

Set the Auto-Hold Type: None, Above
Setpoint, Below Setpoint, Band.

Set Events 1-5: Press or to
toggle between Active and Inactive.
9. Step Set the target setpoint (degrees centigrade)
10. Dwell 
Choose time to dwell at setpoint.
Specify Auto-Hold type: None, Above
setpoint, Below setpoint, Band