Profile mode – Despatch Protocol 3 Controller User Manual
Page 26
W
ORKING WITH
O
PERATING
M
ODES
Protocol 3 Controller
Owner’s Manual
26
Version 1.2
Copyright © 2013 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
b. Press
or
to navigate to the desired time or temperature units.
c. Press
.
d. Press
or
to change the SP value.
e. Press
.
f. Press
to return to normal display.
10. To return to
Stopped Mode
at any time, press
and the Cycle Complete LED will
illuminate.
11. Press
to return to
Select A Mode
screen.
5.2.3.
Profile Mode
Navigate to HLSP to set the High Limit Setpoint before running a profile. Use Profile Mode to
select and run profiles that are programmed into the unit (Figure 7). Press
or
to
navigate,
to select the highlighted profile. Press
to start profile. Press
to stop the
profile and
to exit Profile Mode (profile must be stopped to exit Profile Mode).