Dascom TallyCom III Installation & Operators Guide - Manual (Page 48)

Appendix C. Error Messages
C.1 Recoverable errors
Recovery procedure from these errors is as follows:
Correct the error from the host system according to the error message.
The recoverable error messages consist of the following:
ESCAPE SEQUENCE ERROR XXXX
where XXXX indicates one of the following diagnostic messages:
2001 Escape sequence ERROR in call function # 001
2nnn Escape sequence ERROR in call function # nnn
2255 Escape sequence ERROR in call function # 255
2303 Function not supported
2309 Illegal separator
2311 Syntax ERROR
3002 No space left in dynamic area
C.2 Non-recoverable hardware errors
Recovery attempt can be made as follows:
Turn power off for 10 seconds and then on again.
If the problem persists, contact technical assistance.
The non-recoverable error messages consist of this message:
HARDWARE MALFUNCTION. Call for service. XXXX
where XXXX indicates one of the following diagnostic messages:
Non-Volatile Memory Error:
5002 Hardware ERROR in NVRAM
5003 Checksum in NVRAM is wrong
5004 Validation value in NVRAM is wrong
5005 NVRAM verification ERROR in cell
5006 Values are now overwritten by factory defaults
EPROM Error:
6001
EPROM checksum ERROR
RAM Error:
7001 Main processor RAM ERROR
Interface Error:
8002 Wrong data in selftest
8003 Wrong word in selftest
8004 Response missing from COAX IF.
48