Dascom TallyCom III Installation & Operators Guide - Manual (Page 25)

It may be necessary to re-define the escape character, otherwise it may cause problems as
the escape character is defined in LU3.
EXAMPLE: %Y8,30%
sets French 105 character set for Coax.
FUNCTION 9: PRINT QUALITY
This function is used to select current and default font under the Page Presentation Media command.
SYNTAX: %Y9,%
OPTION DESCRIPTION
0 No quality command sent to printer
1 Font 1, Draft Print Quality.
2 Font 2, Near Letter Quality
3 Font 3, Correspondence Quality
RELATED: Y22, Printer Driver Selection
NOTE:
1. At power up the Default Print Quality is loaded from the front panel setup of the printer.
Function X1 has no effect.
2. Value 3, Font 3, Correspondence Quality, will not be supported in the 4 preprogrammed
printer drivers. However, it may be implemented in the customer specfic printer driver (i.e.
Y22 = 0).
EXAMPLE: %Y9,2%
will select Near Letter Quality.
FUNCTION 11: PAPER PATH
This function is used for selecting default paper path under Page Presentation Media command.
SYNTAX: %Y11,%
OPTION DESCRIPTION
*1
Tractor Feed
2 Automatic Cut Sheet Feeder, Tray 1
3 Automatic Cut Sheet Feeder, Tray 2
4 Automatic Cut Sheet Feeder, Tray 3
NOTES:
1. Before you select one of the options, make sure that the printer can perform what you have
selected. If you e.g. select 3, Automatic Cut Sheet Feeder, tray 2, the printer should have a
dualbin cut sheet feeder installed containing paper.
2. If the command is placed as the first printable character on the page, the changed format will
be effective as soon as the printer receives the command. If the command is placed at any
other position on the page, the change will be effective on the next page.
3. If function 11 is set to 1, and function Y5, Form Length, is set to a value other than 0, a form
length is downloaded to the printer
If function 11 is different from 1 (and function Y5 > 0), a form length of 127 lines is
downloaded to the printer.
25