Dascom TallyCom III Installation & Operators Guide - Manual (Page 28)

1. At power up the value for Form Feed after Local Copy is loaded from the front panel setup of
the printer. Function X1 has no effect.
2.
3. Operator initiated local copy depends on PCIA address 11 and 17 on bit 3 and bit 4. which
are to be found in an ONLINE Hex dump.
NB: Bit 3 must be 1 and bit 4 must be 0 for the datastream to be recognized as an operator
initiate local copy
4. This function corresponds to the following IBM RPQ options:
4214: OPT 20=3.
3268: SC9508
3287: MC3750
5. This function only affects local copy, not host initiated local copy.
6. Available only in non-SCS operation.
EXAMPLE: %Y26,1%
will set FF after local copy.
FUNCTION 27: LOCAL COPY IMAGE
This function implements an IBM RPQ and compatibility modes for other converters.
SYNTAX: %Y27,%
OPTION DESCRIPTION
*0 Null line suppression in formatted operator
initiated local copy and formatted non-SCS print (LU3).
True
screen image in unformatted operator initiated local copy
and unformatted non-SCS print.
1 Null line suppression in formatted non-SCS print.
True screen image in unformatted non-SCS print.
Formatted and unformatted operator initiated local
copy.
Formatting: In operator initiated local copy, the
PCIA (printer control infomation area) will be overwritten
according to the formatting and consequently a command of
CR, NL or EM will always take precedence.
2 Null line suppression in formatted and unformatted
operator initiated local copy.
True screen image in formatted and unformatted
non-SCS print
Formatting: In non-SCS print, PCIA will be
overwritten according to the formatting and
consequently a command of CR, NL or EM will
always take precedence.
3 True screen image in both formatted and
unformatted operator initiated local copy and non-
SCS print.
Formatting: In both non-SCS print and operator
initaited local copy PCIA will be overwritten
according to the formatting. However, a command
of CR, NL or EM will always take precedence.
28