Dascom TallyCom III Installation & Operators Guide User Manual
Page 43
%W2,2222222%
Print "2222222" according to
the
specification
above.
8
overlaps
FUNCTION T: TESTING VIA THE LINE
SYNTAX: %T#
Test 1:
Offline Hex dump ( Coax Only )
This function will only dump the buffer containing the command
sequence.
Test 2:
Online Hex dump
The current buffer contents will be printed and the next buffer
contents will be dumped.
Test 4:
Print out settings
This function is used to print the current settings
Test 5:
Print out character sets
This function is used to print the character sets.
FUNCTION Z: SEND USER STRING
This function will send up to 8 user strings. (from 0-7)
SYNTAX: %Z#
OPTION DESCRIPTION
0-7
Number of defined user strings
RELATED:
Y61, Define User Strings
EXAMPLE: %Z5
will send user string no. 5
FUNCTION X: STORING AND RESTORING SETTINGS
The commands described below allow you to store the temporarily defined settings or to overwrite
these settings by reading the power up default settings. You may also restore the settings to factory
default.
SYNTAX:
%X#
NOTE:
When you change the settings by reading the permanent memory or the factory default settings, the
settings in the temporary memory will be lost.
Selectable values in function X:
43