Dascom TallyCom III Installation & Operators Guide - Manual (Page 23)

000 Set MPP to 256 (SCS command ignored)
LU1
001 to 220 Set MPP in number of characters
LU3
001 to 255 Set MPP in number of characters
132 Factory default
RELATED: Y3,
CPI
NOTES:
1. At power up the MPP is calculated based on the CPI and the Form Width loaded from the
front panel setup of the printer. Function X1 has no effect.
2. When MPP is changed, the change will take place within a currently transmitted print buffer
and will have immediate effect.
3. MPP and the current position will not be changed by changing CPI.
4. MPP for LU1 will apply whether it is set with an SCS command or via function 6.
EXAMPLE: %Y6,80%
will set MPP to 80 characters.
FUNCTION 7: CASE
This function is used for selecting default case.
SYNTAX: %Y7,%
OPTION DESCRIPTION
0 Mono case
*1 Dual case
NOTES:
1. Mono case = Upper case characters only.
2. Dual case = Upper + lower case characters.
3. This function only affects LU3 printing.
4. Can only be overwritten by system if values 0 or 1 are used.
5. A change made in function 7 must be stored in X1 command, as the change only will become
effective at power-up.
EXAMPLE: %Y7,0%
will set default to mono case.
FUNCTION 8: SET LANGUAGE
Use this function for selecting current and default language (LU1 language for Coax).
SYNTAX:
%Y8,%
Twinax
OPTION DESCRIPTION
23