Dascom TallyCom III Installation & Operators Guide - Manual (Page 14)

2. If the permanent memory area is unreadable, the permanent memory area will be reset, the
factory defaults read and an error message will be printed, indicating the action taken (see the
appendix on Error Messages). Operation starts using factory default settings.
3. The interface checks the rest of the printer (self-test). If the printer is malfunctioning, the
Printserver interface will, if possible, indicate error.
4.7.3 Storing and Restoring Settings
The following commands permit you to read and save in the permanent memory area under program
control. You may also read the factory defaults under program control. Overleaf is shown these
commands ("%" is the defined escape character).
%X1 Save setup in permanent memory area (FLASH)
%X3 Read and activate default setup
%X4 Read and activate permanent memory setup (FLASH)
Commands for storing and restoring settings
Note: Please observe that when one of the above commands are used, the temporary escape
character, if any, will be removed.
14