Dascom TallyCom III Installation & Operators Guide User Manual

Page 26

4. Function 11 = 4 (Automatic Cut--Sheet Feeder, Tray 3) will select Envelope feeder in

Proprinter mode (i.e. function Y22 set to 1 or 9).

Function 11 set to 4 is not supported in the pre-programmed Epson Printer Drivers (i.e.
Function Y22 set to 6 or 7).

EXAMPLE:

%Y11,2%

will

select

Cut Sheet Feeder, tray 1.

FUNCTION 22: PRINTER DRIVER SELECTION

This function is for the selecting of printer driver.

SYNTAX: %Y22,%

OPTION DESCRIPTION
n1

"Non-specific"

Printer Driver/Custom Driver

IBM PC Proprinter

Epson

Epson LQ

IBM PC Proprinter XL24

RELATED:

Y11, Paper Path

NOTES:

1. When delivered, the factory default it set to:

7 = “EPSON LQ”.
The default will naturally change when another printer driver is selected.

2. When you change the printer driver via Y22 and wish to store the new setting in the

permanent memory, you must define the escape character again.

Example:
&&??%
%Y22,6%
&&??%
%X1

3. Most functions are related to this function

4. When the Y22 command is received, the RAM is set to default, then the printer driver

parameters, translate tables, strings, etc. are transformed to RAM.

5. The function must be set to 0 in order to use a downloaded Custom specific printer driver.

6. If the function is set to 0, and no custom driver is downloaded, the non-specific driver will be

used (no formatting).

7. The Vertical and Horizontal positions may be lost if a change of printer driver is not made on a

page boundary.

8. 15 CPI is not supported when selecting Y22 = 1 (IBM PC Proprinter). For support of 15 CPI,

Proprinter XL24 will have to be selected. Function Y22 must be set to 9.

9. When using the X3 command to read factory default into RAM, this function will remain

unchanged.

EXAMPLE: %Y22,1%

will select printer driver IBM Proprinter