Dascom TallyCom III Installation & Operators Guide User Manual
Page 27
FUNCTION 23: GRAPHICS PRINTOUT
This function is used for selecting horizontal compensation in graphics.
SYNTAX:
%Y23,
OPTION DESCRIPTION
n1
*0
Graphics will be printed without compensation in horizontal DPI
1
Graphics will be printed with best fit in horizontal DPI but will be
compensated
if
possible.
EXAMPLE: %Y23,1%
sets graphics to be printed with best fit and with compensation
FUNCTION 25: FORM FEED BEFORE LOCAL COPY
This function is used for selecting a Form Feed (FF) to be performed before local copy.
SYNTAX: %Y25,
OPTION DESCRIPTION
*0
No FF before local copy
1
FF
performed
RELATED:
Y26, Form Feed after Local Copy
NOTES:
1. Operator initiated local copy depends on PCIA address 11 and 17 on bit 3 and bit 4. which
are to be found in an ONLINE Hex dump.
NB: Bit 3 must be 1 and bit 4 must be 0 for the datastream to be recognized as an operator
initiate local copy
2. This function only affects local copy, not host-initiated local copy.
3. Available only in non-SCS operation.
EXAMPLE: %Y25,1%
will set FF before local copy.
FUNCTION 26: FORM FEED AFTER LOCAL COPY
This function is used for selecting a Form Feed (FF) to be performed after local copy.
SYNTAX: %Y26,
OPTION DESCRIPTION
0
No FF after local copy
1
FF
performed
RELATED:
Y25, Form Feed before Local Copy
NOTES:
27