Standard wash cycle operation – CHAMPION DH5000T Single Source Gas Manual User Manual
Page 26

18
1. Turn the main power on at the main circuit breaker.
2. Make sure the spray arms and the scrap screens are in place.
3. Turn the water supply on.
4. Close the dishwasher hood.
5. Turn the wash cycle selector switch to the desired standard setting of 1 or 1.5 minutes.
6. Push the dishwasher Power Switch to the ON position. The power switch will illuminate
and the machine will fill with water.
7. Check the pressure gauge as the machine fills and make
sure the incoming water flowing pressure is between 20-22 psi.
Operation
Follow the instructions below to operate the dishwasher in a Standard Wash Cycle. A Rinse
Sentry feature holds the dishwasher in a wash cycle if the booster heater temperature is below
180ºF/82ºC.
Standard Wash Cycle Operation
10
0
30
20
PSI
60
50
40
I
I
O
I
Standard 1 minute Setting
Standard 1.5 minute Setting
! VERY IMPORTANT !
THE STANDARD CYCLE MAY
BE SELECTED BEFORE OR
AFTER THE POWER SWITCH
IS PRESSED; BUT, THE CYCLE
SELECTOR SWITCH WILL NOT
CHANGE THE CYCLE FROM
1 MINUTE TO 1.5 MINUTES
OR VICE VERSA WHILE THE
DISHWASHER IS ALREADY IN
CYCLE.