Auto Meter 6013 - Manual (Page 49)

Chapter 6. Troubleshooting
Race Dash Users Guide 43
Symptom Possible Cause Remedy Notes
Display and alarm
light flash when
the engine is
running Intermittent alarm
caused by a
parameter with its
alarm level set too
close to the normal
operating value Either change the
value for the
alarm or turn the
alarm off Press Switch 2 to
see which sensor is
causing the alarm.
Interference from
Ignition system &
HT Leads Fit Suppressed
(Silicon) HT
Leads. Fit a
suppression
capacitor (2.2uF)
between the coil
(battery
connection) &
chassis Use ‘Helical’
suppressed leads in
extreme cases Display works OK
until engine starts
then Display
freezes or resets
continuously.
Display recovers
once engine
stopped.
Dash wiring close
to HT leads & or
injector leads, or
HT leads tied to
isolated metal work
to which Dash
wiring is also tied. Run Dash wiring
away from HT
leads & injector
leads Recommended
Minimum spacing
3.0”