Auto Meter 6013 - Manual (Page 12)

Chapter 3. Operating the Display System
6 Race Dash Users Guide
Chapter 3. Operating the Display System
This chapter takes you through the operation of the system so
that you can familiarize yourself with its use before you install it
in the vehicle.
Switching the Display System On
You will have switched the system on already if you have
followed the instructions in the previous chapter and have just
set the system up for the first time before installing it.
When installed in the vehicle, the system is switched on when
you switch the ignition on.
When the power is first switched on, the digital display will
immediately show a "Low Oil P" warning and the alarm light
will come on. The tachometer will reset itself by moving the
needle until it touches the stop-pin and then moving it back to
the zero RPM position. Press Switch 2 or Switch 3 to clear the
warning message from the display.
The digital display panel and the analog dial face are always
backlit when the system is switched on
If none of these actions occurs when you switch on, switch off
the power to the system and consult the section on
troubleshooting in this manual.
Changing the Display Layers
The digital display can show separate sets of parameters and
their values on the various display layers.
Each of the display layers can be displayed in turn by pressing
Switch 3. Press switch 3 when the last display layer is being
displayed in order to return to the first display layer. The Display
System will remember which display layer was showing when
the unit was switched off and will redisplay that layer at power-
up.