Auto Meter 6013 - Manual (Page 22)

Chapter 3. Operating the Display System
16 Race Dash Users Guide
Replaying the Recorded Data
Once the selected run is replaying, the display layers work in the
same way as they did when the run was being recorded.
You may press Switch 4 at any time to pause the replay.
Pressing either Switch 1 or 2 will nudge the replay forwards or
backwards by the preset number of seconds.
A summary of the switch actions is shown in the table
below:
Switch
Action
1 Nudge replay backwards XX seconds
2 Nudge replay forwards XX seconds
3 Change to next display layer or cancel a
displayed message
4 Toggle Pause function; press once to pause,
press again to restart
1 & 4 Exit back to the Run Selection Menu before the
replay has finished.
It is not possible to display peak values during the replay. The
original peak values are retained for viewing in Normal Mode.
The number of seconds which the replay can be nudged forwards
or backwards can be set in the Configuration Menus. The
default is ±10 seconds. The switches do not auto-repeat so, for
example, going forwards 40 seconds will require Switch 2 to be
pressed four times. Pressing the nudge switches will cancel any
displayed message before performing the nudge.
The display will change to a Run Navigation display while
Switches 1, 2 or 4 are held, showing the switch function and the
time position in the run.
Once the selected run has finished replaying, the Run Selection
Menu will be redisplayed.