Auto Meter 6013 - Manual (Page 46)

Chapter 6. Troubleshooting
40 Race Dash Users Guide
Symptom Possible Cause Remedy Notes
Switch 4: does
not set or
display pop-up
lap times when
no automatic
receiver in use Switch 4 faulty Replace
switch Disconnect the
switch and short
the leads
together. If the
display changes
replace Switch 4
Otherwise check
wiring.
Faulty switch
wiring
Check switch
wiring for
correct
continuity. Pin U to yellow
S4 wire less than
1.0 Ohm and Pin
U to Pin H
(ground) greater
than 1M Ohm
Lap marker
receiver lead
faulty Check lap
marker wiring Lap time is not
displayed
automatically
(Automatic
receiver is fitted)
Lap marker
receiver faulty Replace lap
marker
receiver
Disconnect
receiver and
press lap
Switch 4. If
display changes
replace receiver
after checking its
wiring.
Bulb has burnt
out Replace bulb Swap with the
other light to
confirm burnt-out
bulb. If not burnt
out, check wiring. External warning
light dead when
the display
warning light is
OK
Faulty wiring to
light Check
continuity of
wiring. Pin G to red AL
wire less than 1.0
Ohm and Pin N to
yellow AL wire
greater than 1.0
Ohm
External gear
shift light dead Bulb has burnt
out Replace bulb Swap with the
other light to
confirm burnt-out
bulb. If not,
check wiring
Faulty wiring to
light Check
continuity of
wiring: Pin G to red SL
wire less than 1.0
Ohm and Pin M to
green SL wire
greater than 1.0
Ohm