Auto Meter 6013 - Manual (Page 19)

Chapter 3. Operating the Display System
Race Dash Users Guide 13
Lap Times
The lap time is displayed for a preset time either when triggered
by the infra-red lap time sensor passing the lap time beacon or
when the driver presses Switch 4
You can adjust the preset display time when you configure the
Display System. See Chapter 4, Configuring the Display System
in this manual.
The most recent lap time is held in display layer 3. Press switch 3
to see this display layer. This display gives you the lap number
and time of the last recorded lap.
Resetting the Lap Time to Zero
Press and hold Switch 1 and then press Switch 4 to reset the lap
count and lap time to zero.