Auto Meter 6013 - Manual (Page 28)

Chapter 5. Installing the Display System
22 Race Dash Users Guide
Fitting the Display Module
The Display Module is fitted into a cut-out in the instrument
panel/dashboard and secured using the two U-brackets at the
rear. The dimensions for the cut-out are shown below. A full
size template can be found in Appendix A.
190mm (7.48 in.)
89.5mm (3.52 in.) 95mm (3.74 in.)
37.5mm
(1.48 in.)
5.5mm (0.22 in)
Rad. Typ.
42.5mm (1.67 in)
Rad. Typ.
54.5mm
(2.15 in.)
5.5mm
(0.22 in.)
97mm
(3.82 in.)
Positioning the Display Module
Ensure that there is sufficient space behind the cut-out to allow
the wiring harness to be connected to the 19-way connector
without any tight bends to the wiring near the connector.
The Display Module must be positioned on the dashboard so that
the driver can see it, either over the steering wheel or through it.
The Display Module should be aligned so that the driver looks at
it square or from slightly above or below.