Atop Technology SE5002 User manual User Manual
Ablelink, Se5002 ethernet serial server, User’s manual
Table of contents
Document Outline
- Published by
- Introduction
- Packaging
- Modes of Operation
- Hardware Description
- LED Status
- Software
- Configuration by SerialManager
- Configuration by Telnet utility:
- Telnet to the system
- System main menu
- System configuring using Telnet
- Network configuring using Telnet
- changing password using Telnet
- Com1 setup
- Link Mode-TCP server setup
- Link Mode-TCP client setup
- Link Mode-UDP client setup
- Com port setting
- Com port-Enabling serial data buffer
- Setting packet delimiter timer
- Setting packet delimiter-character pattern
- 3.3 Configuring Using Web Browser
- 3.3.1 Log in
- login the system via Web
- Overview
- 3.3.2 Changing password
- Change the password
- 3.3.3 Networking
- Network setup
- 3.3.4 Configuring SE5002 as TCP server：
- Com1 setup-TCP server
- 3.3.5 Configuring SE5002 as TCP client：
- Com1 setup-TCP client
- 3.3.6 Pair Connection(Tunneling Mode)
- Com1 setup –pair connection
- 3.3.7 Configuring SE5002 in UDP mode：
- Com 1 setup –UDP mode
- Configuration successfully updated
- Data Transmission in a UDP Master(Client) Mode
- Data Transmission in a UDP Slave(server) Mode
- 3.4 Assigning new IP Address with ARP commands
- 4. Using Virtual COM
- 5. SNMP Setup
- Diagnostics
- Appendix A: Specification
- Appendix B: Upgrade System Firmware
- Appendix C: Re-loading System Firmware
- Appendix D: Using SerialManager