B.2 error messages – Atop Technology SE5001 Series User Manual

Page 79

User Manual Version 1.6

SE5001 Serial Device Server

9. Repeat the process above again for kernel or AP firmware if necessary.

Note: After the upgrading process finishes, SE5001 will program the flash memory and buzzer beeps 6
times then restarts. Normally, it takes around 10 seconds to complete the programming process. If an error
occurs during the programming process, SE5001 will clear the corresponding memory and the system
remains intact of what it was.

B.2 Error Messages

Firmware upgrade may not be successful if errors occur during the process.

Error Cause

Message

Comments

Illegal Hex file format

Hex File Text Error

Hex File Check-Sum Error

Hex File Format Error

Hex File End of Record Error

SE5001 handshaking problem

SE5001 ACK Start Address Error

SE5001 ACK Length Error

SE5001 Response Command Error

Configuration file

Remote IP not found

Open configuration file failure