Tcp server application: enable reverse telnet, Figure 3.32) – Atop Technology SE5001 Series User Manual
Page 40
User Manual Version 1.6
SE5001 Serial Device Server
Copyright © 2011 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
39
Figure 3.32 TCP Client with Pair Connection Enabled
to configure SE5001 in TCP Client mode properly.
Check Enable Pair Connection to enabled Pair Connection application in SE5001.
Scroll to the bottom of the page and c
lick on “Save Configuration” button to save the changes.
Match the Destination IP and Port here with the settings of Pair Connection Master
’s IP and Listening
Port setup previously.
3.3.15. TCP Server Application: Enable Reverse Telnet
Reverse Telnet application is useful if a telnet program is used to connect to SE5001 and the serial interface of the
SE5001 is connected to a Terminal Server. Telnet programs in Windows / Linux usually require special
handshaking to get the outputs and formatting show properly. SE5001 will interact with those special commands
(CR/LF commands) if Reverse Telnet is enabled.