Atop Technology SE5001 Series User Manual
Page 39
User Manual Version 1.6
SE5001 Serial Device Server
Copyright © 2011 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
38
3.3.13. TCP Server Application: Configure SE5001 as a Pair Connection Master
Pair Connection is useful when pairing up two serial devices over the Ethernet or when it is impossible to install
Virtual COM in the serial device. Pair connection does require two SE5001s to work in pair, one would be the Pair
Connection Master (0) and the other would be the Pair Connection Slave.
Figure 3.31 TCP Server with Pair Connection Enabled
Follow section
to configure SE5001 in TCP Server mode properly.
Check Enable Pair Connection to enabled Pair Connection application in SE5001.
Scroll to the bottom of the page and c
lick on “Save Configuration” button to save the changes.
Go to the Pair Connection Slave Setup below (section
). Remember SE5001
’s IP address and the
Local Listening Port here in order to enter this information in the Pair Connection Slave later.
3.3.14. TCP Client Application: Configure SE5001 as a Pair Connection Slave
A Pair Connection Slave (Figure 3.32) needs to pair up with a Pair Connection Master. Please setup a Pair
Connection Master first before proceeding.