Networking setup – Atop Technology SE5001 Series User Manual

Page 30

User Manual Version 1.6

SE5001 Serial Device Server

3.3.2. Networking Setup

Configure IP, SNMP, and alert settings on this page. Please fill in the IP information in the fields under the TCP/IP
header (Figure 3.22). Alternatively, enable DHCP to obtain IP address, gateway and subnet mask from a DHCP
server automatically.

Figure 3.22 IP Information Setup

Enable SNMP and Alert Events

by checking “Enable” (Figure 3.23). Fill in SNMP information in the fields under the

SNMP header. Enable different Alert Events to send these events to a SNMP Trap Server.

Cold/Warm Start: Triggers when the device is rebooted from the application level or physical level.

Link Down: Triggers when the TCP connection of the designated COM port is closed

Link Up: Triggers when the TCP connection of the designated COM port is established

Authentication Failure: Triggers when the username/password entered in the Telnet console or the WebUI is
incorrect.