AirLive WN-250R - Manual (Page 71)

2. System and Network Setup
AirLive WN-250R User’s Manual 62
After you finish with all settings, please click ‘Apply’ (6) button and the following message
will be displayed on your web browser:
Please click ‘Continue’ to back to previous setup menu; to continue on other setup
procedures, or click ‘Apply’ to reboot the router so the settings will take effect (Please wait
for about 30 seconds while router is rebooting).
If you want to reset all settings in this page back to previously-saved value, please click
‘Cancel’ button.
2-6 Wired LAN Configurations
Before all computers using wired Ethernet connection (i.e. those computers connect to this
router’s LAN port 1 to 4 by Ethernet cable) can communicate with each other and access
internet, they must have a valid IP address.
There are two ways to assign IP addresses to computers: static IP address (set the IP
address for every computer manually), and dynamic IP address (IP address of computers
will be assigned by router automatically. It’s recommended for most of computers to use