AirLive WN-250R - Manual (Page 18)

2. System and Network Setup
9 AirLive WN-250R User’s Manual
5. Please check all LEDs on the front panel. ‘PWR’ LED should be steadily on, WAN and
LAN LEDs should be on if the computer / network device connected to the respective
port of the router is powered on and correctly connected. If PWD LED is not on, or any
LED you expected is not on, please recheck the cabling, or jump to ‘4-2
Troubleshooting’ for possible reasons and solution.
2-2 Connecting To Wireless Broadband Router By Web Browser
After the network connection is built, the next step you should do is setup the router with
proper network parameters, so it can work properly in your network environment.
Before you can connect to the router and start configuration procedures, your computer
must be able to get an IP address automatically (use dynamic IP address). If it’s set to use
static IP address, or you’re unsure, please follow the following instructions to configure your
computer to use dynamic IP address:
If the operating system of your computer is….
Windows 95/98/Me - please go to section 2-2-1
Windows 2000 - please go to section 2-2-2
Windows XP - please go to section 2-2-3
Windows Vista - please go to section 2-2-4