AirLive ARM-104 v3 - Manual (Page 122)

AirLive ARM-104_v3 ADSL2/2+ Router 116
4.5.5 TOOLS - Ping Test
Once you have your ARM-104_v3 ADSL2/2+ Router configured, it is a good idea to make sure you can Ping
the network. Figure below shows the default Ping Test screen, which can be accessed by clicking on the Ping
Test link from the left of the Tools screen. If you have your PC connected to the ARM-104_v3 ADSL2/2+
Router via the default DHCP configuration, you should be able to Ping the network address 192.168.1.1. If
the pings for both the WAN side and the LAN side are complete, and your have the proper protocol
configures, you should be able to surf the Internet.
„ Enter IP Address to ping: Enter the IP address that you want to ping. The default is set to the
default IP address of you ARM-104_v3 ADSL2/2+ Router is “192.168.1.1”.
„ Packet size: You can define the packet size of the ping test. The default is 64 bytes.
„ Number of echo requests: You can define how many times the IP address will be pinged. The
default is 3 times.
„ Test: Click Test to start the ping test. The result will be shown in the window underneath.