AirLive ARM-104 v3 - Manual (Page 116)

AirLive ARM-104_v3 ADSL2/2+ Router 110
4.5.1 TOOLS - System Commands
Figure below shows the default System Commands screen, which can be accessed by clicking on the
System Commands link.
„ Restart: This button enables you to restart the system. If you have not saved your configurations,
the ARM-104_v3 ADSL2/2+ Router will revert back to the previously save configuration upon
re-starting.
Note: Connectivity to the unit will be lost. You can reconnect after the unit reboots.
„ Restore Defaults: Use this button to restore factory default configurations.
Note: You will be redirected to the ARM-104_v3 ADSL2/2+ Router Homepage after the unit has
successfully been restored to factory default configurations.