AirLive ARM-104 v3 User Manual
Page 113
AirLive ARM-104_v3 ADSL2/2+ Router
107
4.4.11.1 Dynamic Routing Configuration Procedure
1. Check
Enable RIP.
2.
Select the RIP Protocol RIP v2 for training purpose. The Enable Password field is enabled.
Note—The same RIP protocol should be used to enable dynamic routing on all routers on the network.
3. Check
Enable Password and enter a password. This is an optional field for additional security.
4.
For LAN group 1 and LAN Group 2, leave “Both” checked in the Direction field.
5. Click
Apply to temporarily save the settings.
6. Click
Apply again when you finish making all the changes.
7.
To make the change permanent, click on Save All.