2N Analogue UMTS gateway 2N SmartGate UMTS - Manual, 1699 v1.1.0 - Manual (Page 51)

Table of Parameters 3.2
51
Global initialization Function No.: 999
Initialization of all 2N® SmartGate UMTS parameters including the PIN and
service password.
Only Global initialization can be done by phone line programming. As parameter
of this function service password followed by must be used. This operation
isn’t followed by confirmation tone. Successful setting is followed by pause
(aprox.10s), during this time period is performed reset of configuration memory.
Than is the gateway restarted.
Security Parameters
PIN – value Function No.: 700
Fill in the PIN value for automatic PIN entering upon 2N® SmartGate UMTS
power up. It is applied only if the SIM card is PIN secured. If the given PIN fails
to match the SIM, it is deleted automatically. If entered via a telephone line
upon 2N® SmartGate UMTS start, the PIN is stored automatically.
Setting options: 0, 4-8 characters (0-9)
Upon full initialization: blank
Service password Function No.: 900
Fill the service password for programming via a telephone line. Some parameters
can be programmed by DTMF dialing and so the access to programming must be
password-protected.
Setting options: 4-8 characters (0-9)
Upon full initialization: 12345