2N Analogue UMTS gateway 2N SmartGate UMTS - Manual, 1699 v1.1.0 - Manual (Page 31)

Table of Parameters 3.2
31
Setting options: YES(1)/NO(0)
Default setting: YES
Signaling
Line reversal indication for call in progress Function No.:110
Select call in progress signaling by telephone line polarity reversal on FXS
interface. There is voltage of reversed polarity on the telephone line during the
whole call.
Setting options: YES(1)/NO(0)
Default setting: NO
Tariff pulse when call starts/ends Function No.: 111
Signaling of call start or end by tariff pulse.
Setting options: None (0)-2N® SmartGate UMTS doesn't send tariff
pulse as signaling of callstart/end.
Call end (1) -2N® SmartGate UMTS sends tariff pulse
when call ends.
Call start (2)-2N® SmartGate UMTS sends tariff pulse
when call starts.
Call start and end (3) -2N® SmartGate UMTS sends
tariff pulse when call starts and ends too.
Default setting: None
Tariff pulse frequency Function No.: 112
Tariff pulse frequency setting.
Setting options: 16 kHz (0) -2N® SmartGate UMTS transmits 16 kHz
tariff pulses
12 kHz (1)-2N® SmartGate UMTS transmits 12 kHz
tariff pulses
Default setting: 16 kHz
Tone settings
Dial tone – Double frequency tone[Hz] Function No.: -
Parameter can be set for all three types of tone (Dial tone, Busy
tone,Ringbacktone). This parameter is intended for switching between single
tone and double tone setting. When the parameter is set, the second frequency
of appropriate tone must be set too. When this parameter isn’t set, the second
frequency is automatically set to the same value, which results in single tone
generation. This parameter can’t be set using phone line programming. When
the phone line programming is used for frequency change, both tones must be
set (for single frequency to the same value).
Setting options: YES/NO
Default setting: NO