2N Analogue UMTS gateway 2N SmartGate UMTS - Manual, 1699 v1.1.0 - Manual (Page 28)

2N® SmartGate UMTS parameters configuration 3.1
28
Monitoring
Monitoring is active when 2N® SmartGate UMTS is in operation and registered to
the UMTS/GSM network. If 2N® SmartGate UMTS is not registered to UMTS/GSM,
the USB port is blocked and no monitoring can be made.
This simple informative function helps you identify:
n The UMTS/GSM module type and IMEI ID;
n The SIM card IMSI ID and selected SMS service centre necessary for SMS
sending;
n The UMTS/GSM provider's name and signal strength received by 2N®
SmartGate UMTS - this information helps you find the optimum signal location
(the information is updated in 10s intervals);
n The 2N® SmartGate UMTS line status – standby, outgoing call, incoming call
including telephone number. The COM is locked during dialing and incoming call
ringing, so the PCManager reports COM blocking.
Firmware Upgrade
The manufacturer responds to clients' requirements with periodical firmware
updating. The current 2N® SmartGate UMTS firmware, PCManager and User
Manual are available on www.2n.cz . The latest firmware version is always included in
every new PCManager installation.
Upgrading procedure:
1. Run the PCManager, select the language for displaying texts on the right-hand
side.
2. In menu SmartGate use Upgrade. When the gateway is not in programming
mode, you will be instructed to switch the gateway on and on.
3. If there is more then one file in the PCManager directory, chose one of them.
The upgrade takes place automatically. Do not switch your PC or 2N®
SmartGate UMTS off during the process of upgrading!
Caution
n The PCManager checks the software version in 2N® SmartGate UMTS and
the upgrade file. If the version in the file is new, everything is all right. An
identical or earlier software version is stored in 2N® SmartGate UMTS too
but the PCManager requires confirmation to be on the safe side.