2N Analogue UMTS gateway 2N SmartGate UMTS - Manual, 1699 v1.1.0 - Manual (Page 21)

Telephone line connection 2.4
21
2.4 Telephone line connection
DialThru gateway – basic connection
Phone set is normally connected to extension line of PBX. Wire up 2N® SmartGate
UMTS between phone set and PBX. Link extension line of PBX to FXO interface and
phone set to FXS interface on SmartGate UMTS.
If FXO interface of 2N® SmartGate UMTS is connected directly to PSTN, you can
connect only equipment that is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC to FXS port.
Gateway for extension line of PBX
Link free extension line of your PBX to FXO interface on SmartGate UMTS. FXS
interface remains unconnected.
Gateway for trunk line of PBX
Link free trunk line of your PBX to FXS interface on SmartGate UMTS. Program PBX
to route all UMTS/GSM calls to SmartGate UMTS. Incoming calls from UMTS/GSM
network will be routed to PBX.
You can connect a standard telephone, answering machine or any other FXO-interface
terminal to SmartGate UMTS. Outgoing calls from phone will be routed to UMTS/GSM
network, incoming calls from UMTS/GSM will ring on the phone.
2N® SmartGate UMTS is equipped with the FSK-based CLIP and so it is advantageous
to connect a terminal that is able to display or process the CLI. You must activate the
function on SmartGate UMTS.
Tip
n 2N® SmartGate UMTS is equipped with the FSK-based CLIP and so it is
advantageous to connect a terminal that is able to display the CLIP.
Gateway for both, trunk and extension, lines of PBX
2N® SmartGate UMTS is very flexible thanks to his three routing tables. You can
connect trunk and extension lines of one PBX to proper connectors on SmartGate
UMTS. You can program the complex as follows: outgoing calls from PBX will be
routed through trunk line to UMTS/GSM network. Incoming calls from UMTS/GSM
will be routed to extension line of PBX. This configuration is suitable for PBX’s with
no capability of dial-in on trunk lines.