2N Analogue UMTS gateway 2N SmartGate UMTS - Manual, 1699 v1.1.0 - Manual (Page 17)

Before You Start 2.2
17
2.2 Before You Start
Product Completeness Check
Check the product for completeness before installation please:
n 1× 2N ® SmartGate UMTS
n 1× Magnetic Antenna with coax cable
n 1× Supply adapter
n 2× Telephone Cable
n 1× PC-connection USB cable
n 1× SMS sending input connector
n 2× Dowel
n 2× Screw
n 1× CD-ROM with User Manual and software 1)
n 1× Quick Installation Guide
Note
n 1) Enclosed software:
2N® SmartGate PCManager
2N® SmartGate SMS gateway for easy SMS sending and receiving
2N® SmartGate UMTS Driver for PC
User Manual in PDF format
Installation requirements
n 2N® SmartGate UMTS is designed for vertical mounting on suspension holes
(use the mounting pattern). This position is the best for signal reception because
a vertical antenna is used. 2N® SmartGate UMTS can be operated in the
horizontal position too where the UMTS/GSM signal is good.
n Install 2N® SmartGate UMTS with respect to the UMTS/GSM signal strength –
check the signal strength using the PCManager.
n Place 2N® SmartGate UMTS out of range of sensitive devices and human bodies
for electromagnetic interference reasons.
n For the allowed range of operating temperatures refer to the “Technical
Parameters”.
n 2N® SmartGate UMTS can disturb other telecommunication systems. Place
phone lines and connected terminals and PBX’s faraway from antenna.
n It is impossible to operate 2N® SmartGate UMTS on sites exposed to direct
solar radiation or near heat sources.