2N Wireless 3G router 2N EasyRoute_old design - User manual, 1571 v1.06 - Manual (Page 40)

Table of Programmable Parameters 3.2
40
Replace ‘+’ by
If this parameter is enabled, the ‘+’ character is replaced with the defined string
in the international prefix of the CLI. It is because the ‘+’ character can neither be
transmitted by the FSK protocol nor dialled in the DTMF format from a terminal.
Setting options: 0–15 characters (0–9, *, #)
Signalling ER
Pulse frequency
Set the tariff pulse frequency.
Setting options: 12/16 kHz
Tariff pulse when call starts
Enable/disable tariff pulse sending when the call begins. The pulse is sent when
the call is answered in the GSM network.
Tariff pulse when call ends
Enable/disable tariff pulse sending when the call ends. The pulse is sent when the
call is hung up in the GSM network.
Advanced ER
Receive Path High Pass Filter
Enable/disable the high pass filter for the signal receive path.
Transmit path high pass filter
Enable/disable the high pass filter for the signal transmit path.
Receive Path Gain
Set the gain for the receive path.
Setting options: 0 dB
3.5 dB
-3.5 dB
Muted
Transmit Path Gain
Set the gain for the transmit path.
Setting options: 0 dB
3.5 dB
-3.5 dB
Muted
Line Capacitance Compensation
Set the line capacitance compensation.
Setting options: Off
4.7 nF