Snorkel TL39T - Manual (Page 73)

Rev C page 13-1
■
Troubleshooting
All of the actions described in this chapter may be
performed by an TL39T operator, a trained and
qualified service technician is not required.
The first column, of the following chart, lists
some common problems encountered by TL39T
operators.
The second column lists some of the causes for
! CAUTION
Any problem that cannot be fixed by actions
listed below should be referred to a trained
and qualified TL39T service technician.
13. Operator’s Troubleshooting
❑
Operator Troubleshooting Chart
Problem Cause Remedy
Engine will not crank. 1. Flat battery. Replace / charge battery.
2. Main circuit breaker, in
ground control box, has
tripped..
Reset circuit breaker , then try to start
the engine. If it will not start, refer the
problem to a qualified service technician.
3. Loose battery terminals . Tighten battery leads at battery.
Engine cranks but will not
start.
1. Out of fuel. Fill the engine with the correct type /
grade of fuel.
2. Fuel tap off. Locate fuel tap on engine and turn to ON.
Engine runs but no
outrigger function.
1. Leg / boom switch in lower
control box incorrectly set
Switch to Stabilisers to operate
stabilisers.
Engine runs but no boom
function.
1. Speed control set too
SLOW.
Turn Speed Control C.W. until function
starts.
2. Stabilisers not set correctly. All stabilisers must be set on firm ground
before boom functions will operate.
3. Lack of hydraulic oil. A. Check hydraulic system for leaks.
B. Top up the oil tank with the correct
type / grade of hydraulic oil.
Bleed down at platform
inoperative.
1. Flat battery. A. Charge / replace the battery.
B. Use Manual Bleed Down from lower
station.
each problem. The third column lists remedies.