Snorkel TL39T - Manual (Page 47)

Rev C page 7-7
It is possible to slew the unit or to telescope in
during the lowering process. For correct emergency
lowering operating procedures see “Emergency
Operation” chapter 9.
■
Platform Control Switches
Figure 7.21 - Platform Control Switches
On the ground control box set the Ground/
Platform Selector to platform.
Check that each of the platform moving switches (Œ
through to Œ) cause the platform to move the way it
should.
Check both positions of each switch.
For correct operating procedures see the
”Operation” chapter 8.
NOTE
Pay particular attention to the
Emergency Stop
switch Πto see that it turns the TL39T engine off
when struck.
Pay particular attention to the platform Enable
switch or the platform foot switch (if that option is
fitted) to see that the platform moving switches are
deactivated when the either switch is not operated.
At the completion of the above section the unit can
be returned to the stowed position.
■
AC Outlet RCD/ELCB (option)
Figure 7.22 - AC Outlet RCD/ELCB
If the TL39T has this option fitted check the RCD
works by connecting a power source to the base
inlet and an appliance to the platform outlet.
Push the test button on the RCD/ELCB device and
the power outlet at the platform should not work.
! CAUTION
RCD/ELCB devices should only be replaced
by a qualified electrician.
■
Placards and Decals
Look to see that all placards and decals are in
place and legible. Clean dirty or obscured decals
with soap and water and a soft lint cloth. Replace
any missing or illegible placards or decals before
placing the TL39T into service for the daily work
shift.
NOTE:
Owing to manufacturing variances and customer
preferences there may be some small differences
in the decal layout on specific machines.
NOTE Safety Decals:
Details of the safety decals and their locations are
listed in the Safety chapter(s) near the beginning of
this manual.
■
Placards and Decals
Replacement decals and placards for the TL39T
are available from Snorkel dealers.
❑ Standard placards and decals
See pages 7 - 8 and 7 - 9 for the decal list and
locations of individual decals.
7. Pre-operational Inspection