Snorkel TL39T - Manual (Page 61)

Rev C page 10-1
10. Stowing and Transporting
■
Stowing
At the end of each work day (or in preparation for
lifting or storage) a qualified operator should put the
TL39T into its stowed position then lock by placing
the boom lock pin in position.
❑
The correct stowed position is shown here.
Figure 10.1 - Stowed Position
To bring the TL39T into the STOWED POSITION
use the controls on the ground control box or
platform control box to:
1. Fully lower all booms.
2. Align the boom travel lock with the boom rest
Πmounted to the drawbar (see Figure 10.2).
Figure 10.2 - Locking the Booms
3. Insert the boom pin Πin place (see Figure
10.3) and ensure the pin keeper Πis correctly
locked in place through the boom pin.
Figure 10.2 - Boom Lock Pin
■
Transporting
❑ Trailering
When moving the TL39T on a trans port trailer the
following points must be adhered to.
! DANGER
1. The unit must be in the stowed position.
2. The boom lock MUST be in place.
3. Care must be taken when loading the
unit onto the trailer that it does not run
away. Chock the wheels and apply the
handbrake.
4. The TL39T can be loaded by forklift.
❑
Securing to a Transport Vehicle
5. Tie down only with the 4 tie down lugs (see
Figure 10.4).
Figure 10.4 - Tie Down Lugs
NOTE:
The tie down lugs are located at each corner of the
trailer, two at the front and two at the rear.
! IMPORTANT
DO NOT
Tie down over the draw bar.
Tie down over the booms or level rods.
Tie down over the platform.
Reverse the above procedure after transporting.
Boom
Attachment
Bracket
Trailer
Attachment
Bracket
Holes
Aligned