Snorkel TL39T - Manual (Page 42)

page 7-2 Rev C
The rest of this chapter shows how to perform the
inspection and maintenance required for each item
in the Pre-operational Inspection Table.
■
Engine Fuel Level
Figure 7.1 - Engine Fuel Level
Visually check to see that the gasoline tank is full.
See the “Specifications” chapter 3, fuel for octane
and grade.
■
Fuel Tank Cap
Figure 7.2 - Engine Fuel Tank Cap
Check to see that the tank cap is in place and is
tight.
■
Fuel Leaks
Visually inspect the Honda fuel tank and the entire
length of the fuel line, from the engine to the fuel
tank, for leaks.
■
Engine Oil Level
Figure 7.3 - Engine Oil Level
Remove the oil filler cap and wipe the dipstick
clean. Insert the dipstick into the oil filler neck, but
do not screw it in.
If the level is low, fill to the top of the oil filler neck
with the recommended oil.
Seethe “Specifications” chapter 3, for the correct
engine oil grade and weight.
■
Operator’s Manual
Figure 7.4 - Operator Manual
Check that the Operator’s manual is complete and
in the holder on the platform.
■
Wiring Harnesses
Figure 7.5 - Wiring Harnesses
Inspect all the wiring harnesses, on the machine,
for loose connections, broken wires, and frayed
insulation.
7. Pre-operational Inspection
COMBINED OIL FILLER
CAP AND DIPSTICK
OIL LEVEL FILLED TO TOP
OF FILLER NECK
OIL LEVEL