Snorkel TL39T - Manual (Page 41)

Rev C page 7-1
7. Pre-operational Inspection
At the start of each work day (or 8 hour shift), an
TL39T qualified operator must perform the Pre-
operational Inspection as listed in the table below.
The purpose of the Pre-operational Inspection is to
keep the TL39T in proper working condition and to
detect signs of malfunction at the earliest possible
time.
The TL39T should be in the STOWED POSITION
and the Master Key Switch set to OFF before you
begin this in spection.
Defective parts and/or equipment malfunctions
jeopardize the safety of the operator and other
personnel, and can cause damage to the machine.
! DANGER
DO NOT operate an TL39T that is known to be
damaged or malfunctioning.
Repair all equipment damage or
malfunctions, before placing the TL39T into
service.
■
Pre-operational Inspection Table
Item Service Required
Engine fuel level Look to see that the fuel tank is full
Fuel tank cap Check to see that the cap is tight
Engine oil level Check oil level (between dipstick lines)
Fuel leaks Visually inspect (hoses and connections)
Engine cooling Check that grills are not blocked
Wiring harnesses Visually inspect (installation, condition)
Battery terminals Visually inspect (no corrosion)
Battery fluid level Check fluid level (1/4” or 6 mm below filler neck)
Hydraulic oil level Visually inspect level (between lines on decal)
Hydraulic oil leaks Visually inspect (hoses, tubes)
Tires and wheels Visually inspect (condition)
Tire pressure Check pressure (measure)
Bolts and fasteners Visually inspect (condition)
Structural damage and welds Visually inspect (weld cracks, dents)
Lanyard anchor points Visually inspect (condition)
Platform gravity gate Check condition and operation
Platform guardrails Visually inspect (condition)
Flashing light (option) Visually inspect (operation)
Ground control switches Actuate and inspect for proper operation
Ground control valve levers Check operation (causes correct motion)
Ground emergency lower Check operation (causes correct motion)
Emergency lower Check operation (causes correct motion)
Platform control box switches Actuate and inspect for proper operation
Platform emergency lower Check operation (causes correct motion)
RCD/ELCB AC outlet (option) Check operation
Platform work lights (option) Check operation
Placards and decals Visually inspect (installation, condition)
Platform entry ladder Visually inspect (condition)