Snorkel TL39T - Manual (Page 21)

Rev C page 2-1
2. Safety Devices
■
Safety Device Information
For emergency operation controls and procedures,
see the “Emergency Operation” chapter 9, in this
manual.
The devices listed in this chapter are safety
devices.
They are on the TL39T to increase safety in the
work place for both the operator and other people
near the TL39T.
! CAUTION
DO NOT bypass, disable, modify, or ignore
any of these devices. Check them carefully
at the start of each work shift to see that they
are in working order (see “Pre-operational
Inspection” chapter 7). If any is found
to be defective, remove the TL39T from
service immediately until a qualified service
technician can make repairs.
■
Emergency Stop Switches
❑ At ground control box
Figure 2.1 - Emergency Stop Switch at
Ground Control Box
Press the red EMERGENCY STOP button in, at
any time, under any conditions, and the entire
machine stops, and nothing moves. This switch
must be out (on) for anything on the TL39T to work.
Pull the switch and it will pop out (on).
❑ At platform control box
Figure 2.2 - Emergency Stop Switch at
Platform Control Box
Press the red EMERGENCY STOP button in, at
any time, under any conditions, and the entire
machine stops, and nothing moves. This switch
must be out (on) for anything on the TL39T to work.
Pull the switch and it will pop out (on).
NOTE:
The ground control box is designed to override
the platform control box. If the platform control box
EMERGENCY STOP switch is in (off) the ground
control box can still be used to start and operate
the TL39T.
■
Other Safety Devices
❑ Lanyard anchor points
Figure 2.3 - Lanyard Anchor Points
All personnel on the platform should attach their
fall restraint lanyards to one of the lanyard anchor
points.
The lanyard anchors are located at the rear of the
platform floor.