Apple Macintosh System 7.5 - Manual (Page 32)

7 Make sure that the destination disk indicated on the screen is the one on which you want
to install software.
If the wrong disk name appears, click the Switch Disk button until the correct
disk name appears.
8 Click Install.
9 Follow the instructions that appear on the screen.
10 When you see a message reporting that the installation was successful, click Quit.
If a message reports that installation was not successful, try installing again.
(Follow the instructions on the screen.)
Using Type 1 fonts with QuickDraw GX
Type 1 PostScript fonts must be enabled in order to work with QuickDraw
GX. “Enabling” makes your fonts work with QuickDraw GX. It does not
affect the font outlines, design, or metrics.
Any Type 1 fonts already installed in your System Folder are automatically
enabled when you install QuickDraw GX. If you install additional Type 1
fonts, you need to enable them by using special utility software located on the
QuickDraw GX disks.
To install the Type 1 Enabler fonts, use the Installer to install the QuickDraw
GX utilities. For instructions, see “Installing QuickDraw GX Utilities,” earlier
in this chapter.
24 Chapter 2