Apple Macintosh System 7.5 - Manual (Page 20)

5 Make sure that the destination disk indicated on the screen is the one on which you want
to install system software.
If the wrong disk name appears, click the Switch Disk button until the correct
disk name appears.
6 Click Install.
The Installer updates the software in the System Folder on your hard disk.
If you have any problems while installing: See Chapter 7 (“Troubleshooting”)
later in this manual.
7 Follow the instructions on the screen.
On-screen messages tell you if you need to insert other disks. It takes several
minutes to complete the installation.
8 When the installation is complete, restart your computer.
If for some reason the installation was not successful, try the installation
again.
If you can’t restart the computer: See Chapter 7 (“Troubleshooting”) later in
this manual.
Installing from a CD-ROM disc
If you are using an Apple CD-ROM drive, you should first start up your
computer from the CD, and then install the software. Follow these steps:
1 Insert the CD-ROM disc in the CD-ROM drive.
If you are using an external CD-ROM drive: Turn on the CD-ROM drive and
insert the CD before starting your computer.
If you are using an internal CD-ROM drive that uses a caddy: Insert the CD
before starting your computer.
If you are using an internal CD-ROM drive that does not require a caddy: Turn
on the computer, insert the CD, and then turn off your computer.
12 Chapter 1