Poison Spyder TJ A-PILLAR LIGHT BAR MOUNTS FOR RIGID 50 LED - Manual

©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
INSTALLATION INSTRUC
TIO
NS
TJ A-PILLAR LIGHT BAR MOUNTS FOR RIGID 50” LED
Thank you for purchasing Poison Spyder
products for your Jeep. Installation is fairly simple
with the right tools and good mechanical abilities.
If you are not confident in your mechanical skills,
please seek the help of a professional to perform
the installation. Please read through these entire
instructions before proceeding with installation.
IMPORTANT: Completely install and remove
these items prior to painting or powder coating.
This will allow you to check for fitment or do any
clearancing or fitting ahead of time, to reduce
the chance of damage to the finish during final
installation. Poison Spyder Customs Inc. is not
responsible for costs for or damage to paint or
powder coat finish under any circumstances,
including paint or powder coat of incorrectly
shipped or defective parts.
PARTS LIST
Please check your packages immediately upon
arrival to ensure that everything listed is included,
and to check for damage during shipping. If
anything is missing or damaged, call Poison
Spyder at (951) 849-5911 as soon as possible.
(1) Driver Side TJ A-Pillar Light Bar Mount
(1) Passenger Side TJ A-Pillar Light Bar
Mount
(1) Driver Side TJ A-Pillar Rubber Liner
(1) Passenger Side TJ A-Pillar Rubber Liner
(6) 5/16-18 X 1 SS Button Head Cap Screw
INSTALLATION NOTES
•
If the Light Bar Mounts were received bare,
they will need to be painted or powder coated
prior to final installation. However it is a good
idea to test-fit prior to paint, in order to ensure
proper fitment to ensure against damage to the
paint or powder coat upon final installation.
• Remove the three factory bolts at the
lower corners of the windshield brackets that
correspond to the holes in the mounts. Do not
remove the lower-most bolt on each side—
leave those in place while installing the light
bar mounts.
• Place the supplied rubber liners between the
mounts and the Jeep’s A-pillar before bolting
them on. Use the supplied 5/16-18 X 1 SS
Button Head Cap Screws to secure the mounts
to the Jeep. Make alignment adjustments to
the rubber liners as the bolts are tightened.
• Install the light bar into the tabs at the top
of the mounts AFTER the mounts have been
installed on to the Jeep. It may be necessary
to loosen the mount bolts slightly in order to
slide the light bar studs into the slots. Once
everything is installed and aligned, re-tighten
all hardware.
• This product is designed exclusively for
mounting the Rigid Industries 50” E-Series or
SR-Series LED light bars. No guarantee is
made regarding fitment of other brands of light
bars.
• Routing of electrical cables is left to the
installer’s discretion. We have seen several
different methods of routing the cable, we
encourage you to do a search on the web for
ideas and tips for routing the cables.
• With the SR-Series (single row) light bar, If
the light bar produces an annoying whistle or
harmonics at highway speeds, try flipping it
over. We have had the best results with the
light bar flipped so that the cables route down
the driver’s side.