Poison Spyder YJ BOLT-ON REAR DEFENDER FLARES - Manual

©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
INSTALLATION INSTRUC
TIO
NS
Thank you for purchasing Poison Spyder
products for your Jeep. Installation is fairly simple
with the right tools and good mechanical abilities.
If you are not confident in your mechanical skills,
please seek the help of a professional to perform
the installation. Please read through these entire
instructions before proceeding with installation.
IMPORTANT: Completely install and remove the
these items prior to painting or powder coating
them. This will allow you to check for fitment or
do any clearancing or fitting ahead of time, to
reduce the chance of damage to the finish during
final installation. Poison Spyder Customs Inc. is
not responsible for costs for or damage to paint
or powder coat finish under any circumstances,
including paint or powder coat of incorrectly
shipped or defective parts.
PARTS LIST
Please check your packages immediately upon
arrival to ensure that everything listed is included,
and to check for damage during shipping. If
anything is missing or damaged, call Poison
Spyder at (951) 849-5911 as soon as possible.
(1) Driver Side Bolt-On DeFender™ Flare
(1) Passenger Side Bolt-On DeFender™
Flare
(16) 3/8-16 X 1 SS Flat Head Cap Screw
(16) 3/8-16 Nylon Insert Lock Nut
(16) 3/8 Flat Washer
INSTALLATION NOTES
As there are many possible equipment and
installaiton configurations which will affect the
installation procedure, we are not providing a
detailed step-by-step installation procedure for
this product. Even without detailed instructions,
an acceptable installation may be performed by
a competent mechanic, by putting some care
and time into studying the product, the vehicle,
and taking a thoughtful approach to installation.
While installing these items is considered a “DIY”
project, here are some helpful hints to consider:
•
If installing the Bolt-On DeFender™ Flares
on to a Jeep already fitted with Poison Spyder
Crusher Flares™ with the “Stock” feature set,
the appropriate bolt holes will already exist in
the Crusher Corners™, which will not need to
be drilled. The threaded inserts for the stock
flares, however, will need to be removed from
the Jeep’s body tub.
• If installing the Bolt-On DeFender™ Flares
on to a Jeep already fitted with Poison Spyder
Crusher Flares™ that do not already have the
flare bolt holes (“Standard” or most “Modified”
configurations), or other manufacturers’ full
corner protectors, you will need to drill 3/8” bolt
holes into the corners in order to bolt the Flares
on. Clamp the DeFender™ Flare in place and
use it as a drill guide. Drill all the way through
both the Crusher Corner™/Corner Guard, and
the Jeep’s outer tub.
• If installing the Bolt-On DeFender™ Flares
on to a Jeep already feitted with Poison Spyder
Crusher Corners™ for TJ, or for YJ/CJ with the
TJ Wheel Opening, the wheel opening on the
Bolt-On DeFender™ Flare will match the wheel
opening on the Crusher Corners™, making it
simple to properly align the Flare before drilling
the mounting holes.
• If installing the Bolt-On DeFender™ Flares
on to a Jeep with un-matching wheel opening
(i.e. competitors’ corner guards), carefully
measure and position the DeFender™ Flare
so that the wheel opening is centered over
TJ-YJ BOLT-ON REAR DEFENDER FLARES