Poison Spyder LED LOAD RESISTOR KIT - Manual (Page 2)

INSTALLATION INSTRUC
TIO
NS
Poison Spyder Customs • LED LOAD RESISTOR KIT INSTALLATION Page 2
©2014 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
wire (in this case, the red wire from the LED
Pigtail) through the slot in the connector
that goes all the way through. Leave a few
inches of the red wire poking through the
other side of the connector. Then insert
the lead from the Load Resistor (it doesn’t
matter which one) into the non-through slot
in the connector, and push it in until it hits
the internal stop. Next, use the channel-lock
pliers to crimp the metal tang down into the
connector, which pierces the insulation and
completes the tap. Finish by clasping the
connector’s cover shut.
5. Use a Butt Connector to connect the end
of the red wire to the Stop/Turn Lights hot
lead in the OE harness, which you identified
in Step 3.
6. Use the other Wire Tap Connector to tap
the remaining Load Resistor lead into the
WHITE wire in the LED Pigtail. Repeat the
procedure from Step 4 for installing the Wire
Tap Connector.
7. Attach the ring terminal at the end of the
white wire to a suitable ground.
8. Use the remaining Butt Connector to
connect the end of the BLACK wire in the
LED Pigtail to the Running Lights hot lead in
the OE wiring, which you identified in Step 3.
9. With these connections completed, plug
the LED Lamp into the LED Pigtail and test
operation of the running lights, stop, and turn
lights. If they do not work correctly, check
all of your connections and the routing of
your wiring, using the diagram above for
reference.
10. Affix the Load Resistor to some stationary
location inside the body panel. Note that it
can develop heat, just like the incandescent
lamp it is simulating, so be careful not to
mount it to or near anything that can melt or
be damaged by heat, such as other wiring,
plastic items, painted surfaces, etc.
11. Re-install the LED Lamp into place.
LED LAMP
LED PIGTAIL
LOAD RESISTOR
BUTT
CONNECTORS
WIRE TAP
CONNECTORS
STOP/TURN LIGHTS (+)
CONNECT TO:
RED
BLACK
WHITE
RUNNING LIGHTS (+)
GROUND (-)