Installation instruc tio ns – Poison Spyder JK BRAWLER MID FRONT BUMPER User Manual

Page 3

INSTALLATION INSTRUC

TIO

Poison Spyder Customs • JK BRAWLER MID FRONT BUMPER

Page 3

IMPORTANT: If installing the optional Skid Plate,

refer at this point to the instructions that came

with the Brawler MID Skid Plate, and proceed

with those steps. Return to these instructions

and proceed with the next step, below, once the

Skid Plate installation instructions have been

completed.
7. Install the Bumper onto the frame. There

are eight (8) threaded studs located on the

inside/backside of the bumper, which will

correspond with the bumper mounting holes

on the frame. It may be a tight fit due to

slight manufacturing variances from Jeep to

Jeep, but the bumper will fit with some gentle

persuasion. You may need to use a rubber

mallet or soft dead-blow hammer to tap the

bumper into place. Be careful not to mar your

paint or powdercoat finish.

8. Locate the 1/2-13 nylon insert lock nuts and

1/2” flat washers that came with your bumper

(usually these are shipped threaded onto the

studs). Install a flat washer and lock nut onto

each of the eight bumper mounting studs at

the outside and inside of the frame rail on

either side of the Jeep. Snug these with

the 3/4” deep socket, extension and ratchet.

Torque these nuts to 70 ft.-lbs.

9. If you installed the OE fog lamps into the

Brawler MID bumper, plug the harness

connectors back into the sockets in the back

of each lamp. The OE wire harness may be

secured with stick-on harness anchors and

zip-ties (not provided).

Congratulations, you have completed the

installation of your Poison Spyder JK Brawler

MID Front Bumper!